Wind River Blog: VxWorks 64-bit using Simics

There is a new post at my Wind River blog, about how Simics was used to kick-start the development of the 64-bit version of VxWorks. It is an interesting example of how to use a virtual platform as a model of something much simpler and gentler than actual hardware systems.

Wind River Blog: Testing Integrated Software in Simulation

There is a new post at my Wind River blog, about the testing on an integrated software stack in simulation. I base the discussion on the very interesting report about the Toyota “unintended acceleration” problems and the deep investigation into the control software of the affected vehicles performed by a NASA team (!). The report covers a lot of different tools, but also notes that about the only thing not done was to integrate the complete software stack in simulation.

EETimes: James Aldis on Performance Modeling

James Aldis of TI has published an article in the EEtimes about how Texas Instruments uses SystemC in the modeling of their OMAP2 platform. SystemC is used for early architecture modeling and performance analysis, but not really for a virtual platform that can actually run software. The article offers a good insight into the virtual platform use of hardware designers, which is significantly different from the virtual platform use of software designers.
Continue reading “EETimes: James Aldis on Performance Modeling”